AR-15 Tool (rentals)
Showing all 9 results
for hand reaming or taps
AR-15 Barrel Wrench / Multi-tool$10.00
Multi-Tool you will need when assembling your AR.
AR-15 Buffer Tube Thread Chase Die$12.00
Steel Die is used to chase or re-thread the mounting threads on AR-15 buffer tubes.
1 3/16 – 16 TPI
AR-15 Upper Receiver Die$12.00
Steel Die is used to chase or re-thread the barrel mounting threads on AR-15 upper receiver.
1/2″ x 28 Tap for AR / Muzzle Brakes$14.00
Muzzle brake tap, AR-15 Flash hiders and other common brakes.
AR-15 Barrel Extension Wrench & guide$15.00
Wrench for installing barrel extensions on a barrel, comes with extension guide to align properly.
AR-15 Buffer Tube Tap$20.00
Steel Tap is used to chase or re-thread the mounting threads for AR-15 buffer tubes.
1 3/16 – 16 TPI
Manson Floating Reamer Holder$30.00
1/2″ straight shank for use in all Lathes and Mills.
Micrometer Reamer Stop$30.00
Precision, repeat-ability, and ease of use: these are the benefits of P. O. Ackley Micrometer Reamer Stop. Now you can do production runs with your Chamber Reamer, without having to index each workpiece axially. You’ll be assured of consistent headspace, chamber after chamber!
To set up, insert your Chamber Reamer shank in the Reamer Holder and tighten the two set screws. Then insert the reamer holder into the Stop Cylinder assembly (micrometer threaded Stop Cylinder with .001″ Adjustment Nut, Lock Nut and optional Plug Nut). Make a rough cut in the chamber (leave about .025″ extra material). Now, with the reamer bottomed in the rough chamber, move the Stop Cylinder assembly into contact with the work piece and secure it to the Reamer Holder with three set screws.
You can now adjust the depth of the finish cut in increments of .001″, or even less. The Adjustment Nut is marked with 25 equidistant markings around the circumference, each of which corresponds to .001″ of axial adjustment. By backing off the Adjustment Nut and re-securing the Lock Nut, then repeating the cut, you can zero in on your specified headspace measurement. Adjustments of .0005″ can be made with confidence.
We recommend use with our floating reamer holders for best results.
.437″ straight shank for use in all Lathes and Mills.